This Fi compatible layered Side Release Buckle Biothane collar comes in a 1" standard weight (with a 1.5" wide piece of biothane underneath) collar with two 1" wide tabs that sit on top of the collar to hold your Fi unit; since the Fi sits on top of your collar, no stress is put on the Fi unit. This collar comes with the Fi end links attached (Fi end links are only available in silver). There is no need to unhook your Fi unit from the collar for charging; simply pull the biothane back and place on the charger (see photos attached for an example).
Fi units are NOT included with your purchase. If you do not own a Fi unit, you can purchase one from https://tryfi.com/ and use code 4BLACKPAWS50 for $50 off your purchase.
Every collar in this line is hand crafted from Biothane coated webbing that is durable and easy to clean. It even stays flexible in cold weather! This amazing webbing is soft and has the appearance of leather but is more durable, cleanable, stronger and easier to maintain than leather. It's also:
-stink-resistant **NOT resistant to skunk smell.
-stronger than nylon and leather
-cleanable with soap and water
It is very important to carefully measure your pups neck to get an accurate collar fit as these collars are NOT adjustable. This collar is made with an aluminum or plastic side release buckle that can be engraved with your contact information.
IMPORTANT: Please read the following information regarding sizing:
This specific collar is NOT adjustable and is sized according to the ACTUAL measured length of the collar (collar + buckle). For example, when you order a 16″ collar, the collar will measure 16″ when laid flat from end to end (measurement is from the very end of the female side of the buckle to the end of the Biothane material just before the male side of the buckle). Biothane will NOT stretch over time.
Sizing example: Our dog, Thea, has a 12.5" neck (where her collar naturally sits) and her exact collar measurement is 14".
Want a looser fitting collar? Order your collar 1″-2”LARGER than your dog’s actual neck size (for example, if your dog's neck measures 18", put 19" in the actual collar size box).
Need to measure your pups neck?
Gently use a piece of string or other soft material like a phone charger cord. Hold the end of the string/cable between your finger and thumb and gently wrap the other side around your dog's neck (the base of the neck above the shoulders) where the collar will sit. The tape should be snug but not too tight. If your dog has very thick fur be sure to get the tape closer to the skin. Let go of the string/cord and mark the spot in the middle of the string/cord with your finger that marked your pup's neck size. From there, use a tape measure to get the measurement from your string/cord measurement. After you get your dog's exact measurement, you can then loosen the cord about 0.5" or 1" to see how the collar would fit with a bit of length added for comfort.
**If you are having trouble finding your pup's neck size, please don't hesitate to contact me for help or send pictures of your pups current collar next to a ruler/tape measure for me to help you determine the best size.
Buckles can be engraved at an additional cost.
You can choose up to 3 lines of text. Please note, the more text you choose, the smaller the lettering will be. We recommend no more than 15-18 characters (including spaces and characters) per line.
Each consumer is responsible for determining the suitability of these products for their individual situation. Consumer accepts all responsibility by purchasing and using these products. Four Black Paws is not responsible for any and all injuries that can occur from the improper use of its products.